Green House Manual
Page | 6
Assembling the frame
1.
Once you confirm the correct measurements for each bow connect the top two bow pieces
together by placing the end of the swaged bow piece into the non-swaged piece.
2.
Connect the lower two bow pieces to each side of the bow using the pre-attached sleeve.
3.
Assemle all 3 bows
without
securing them with a screw.
4.
Lay out all your 3 assembled bows and choose which bow will be your front bow, middle bow
and back bow.
5. Before securing the front and back bow with a screw you will locate your clamps and insert
two of them at the top of the bow, right
ABOVE
the sleeve. Take one of the two clamps above
the sleeve on the front and back bow and drag it toward the peak of your bow. These will be
your inwall pipe clamps as shown in the picture. Keep the other clamp right above your sleeve.
This will be your brace clamp. Do this for both sides of the front and back bow as shown in the
front and back bow picture. Now you will take another clamp and slide it
BELOW
the sleeve. Do
this on both sides.
You should now have a total of 6 clamps on your front back bow, 2
ABOVE
the sleeves; one on
each side (
brace clamps
), 2
BELOW
the sleeve; one on each side (
cross pipe clamps
), and 2
at the
peak;
one on each side (
inwall pipe clamps
) of your bow as shown in the front and back bow
picture.
AGAIN, THESE CLAMPS WILL BE POSITIONED THE SAME FOR YOUR FRONT AND BACK BOW
BEFORE SECURING THE BOW PEICES WITH SCREWS
Inwall Pipe Clamps
Brace Clamps
Sleeves
Cross pipe Clamps
FRON
T &
B
AC
K
B
OW
P
IC
TURE
