Green House Manual
Page | 11
Installing your bracing
1.
You will have 4 braces. File the edges of the braces to smoothen out
any sharp edges that could tear into your plastic.
2.
You will install your braces with the prepositioned clamps on your
bows as shown below. You will stick your bolts in from the outside
making sure the
NUTS
are on the
INSIDE
of your greenhouse and
temporarily tighten them.
3.
Before fully tightening the bolts on the clamps to secure the braces,
use a level to make sure
it’s
even and adjust as needed by moving the
temporarily tightened braces and clamps up or down the bows.
4.
Once it is level you can tighten the nut.
5.
You will repeat this process on the opposite side with the 2 remaining
braces. Make sure the nuts are on the inside of your greenhouse.
File the
edges until
smooth
Close up from the
INSIDE
of the
greenhouse of the 2 clamps fully
tightened with the braces
Close up from the
OUTSIDE
of
the greenhouse of the 2 clamps
fully tightened with the braces
