Instruction Manual
Radio control devices T3, T5 and T7 @
2G4
version 1.3 January 14
REM
device
®
- ITALY
page 17 of 28
CHANGING THE BATTERY
Remove the 8 closing screws and open the transmitter cover.
Take out the battery connector and replace it with a new one paying
attention to remove the old adhesive tape replacing it with the new
one supplied. Close the cover and retighten the closing screws.
The battery is not rechargeable, do not apply voltage to its
terminals, do not expose to high temperatures or to flames,
do not try to open it!.
Do not dispose of old batteries in the environment and do not throw
them into the containers for household waste.
The batteries must be disposed of according to local regulations,
using the disposal service available in your own territory.
As an alternative to the battery provided it is possible to use alkaline
batteries or ones that can be recharged with the battery charger
provided.
BATTERY
CONNECTOR
CLOSING
SCREWS
COVER
Figure 7
BATTERY
Figure 8
find inside
biadhesive fixing tape
Instruction Manual
Radio control devices T3, T5 and T7 @
2G4
version 1.3 January 14
page 18 of 28
REM
device
®
- ITALY
CHANGING THE TRANSMITTER
In the event of malfunction, breakage or loss of the transmitter, it is
possible to replace it with a new one.
The programming of the code involves only the transmitter, while the
receiver is combined and tuned automatically, thanks to the exclusive
new patented
“REMSYS CODE”
System
. For this reason the
serial
number
of the radio control device is marked only on the Receiver.
The replacement of the transmitter does not involve any operation of
modifying or labelling the transmitter itself.
•
Disconnect the power from the receiver: if it is powered by the
electric panel of the machine, turn off the main switch.
•
Release
the
red
Stop/Emergency
mushroom button of the transmitter.
•
Press the buttons
2
and
7
together and
simultaneously the Start button
S
, and
release.
The green led ON starts to blink
rapidly.
•
Switch on the power to the receiver.
•
When the transmitter recognises the
receiver, the green led ON lights with a
fixed light.
•
Switch off the receiver by pressing the
red Stop/Emergency mushroom button.
•
Wait about 10 seconds, after which the
new transmitter is ready for use.
If the radio control device does not work, repeat the entire
operation.
1
2
3
4
5
6
7
S
GREEN LED
(ON)
Figure 9
