Instruction Manual
Radio control devices T3, T5 and T7 @
2G4
version 1.3 January 14
REM
device
®
- ITALY
page 11 of 28
TX OFF
TX ON
Command
TX ON
TX OFF
Power ON
Power OFF
REM
device
RADIO CONTROL EQUIPMENT
Frequency
Serial Number
Power Supply
!
R
U
B
Y
-B
O
X
R
E
C
E
IV
E
R
TECHNICAL DATA
Protection degree: IP67
Material: ABS V0
REMsys CODE
Link System
PATENTED - BREVETTATO
90 mm
2
6
0
m
m
The
RubyBox-Terminal
unit, outdoor box must be placed in a
location easily accessible to maintenance personnel and repair.
Connecting the
Rx2G4A Antenna
to receiver RubyBox-Terminal is
made via the supplied cable, or alternatively a cable 6x0,25 twisted
pair. Observe the colour of the wires as shown on the label near the
plug.
Rx2G4A
Rx2G4 Antenna
SERIAL
NUMBER
Figure 4
RBT
RubyBox-Terminal
Instruction Manual
Radio control devices T3, T5 and T7 @
2G4
version 1.3 January 14
page 12 of 28
REM
device
®
- ITALY
The Rx2G4A receiver must not be positioned inside screened metal
structures (boxes, cupboards, trellises, tubes, grids, etc.), so as not
to jeopardise the reception of the radio signal; For better efficiency
must be placed in the area above the work area.
The measurements for drilling the holes for Ruby-terminal are
indicated in Figure 4.
Never make a hole in the box. Avoid precarious fixing systems.
For correct and safe wiring of the Terminal, use a multicore cable
and plug of the same type as those used for the wired pushbutton
panel supplied with the machine.
Use caps to terminate the leads to be tightened to the receiver
terminals and check the fastening accurately.
The simultaneous control of an operating machine with the radio
control device and the wired pushbutton panel is NOT allowed.
Pay particular attention to the connection of the STOP/EMERGENCY
circuit, following and respecting the machine’s original wiring
diagram.
Supplying power to the Receiver
Check that there is a suitable isolating device on the machine. Use a
voltmeter to check that there is a suitable voltage on the machine’s
electric panel to supply the receiver. These feeding voltage values
are given in the paragraph TECHNICAL CHARACTERISTICS and
printed next to the connecting terminals, inside the receiver.
The phase and neutral or positive and negative polarities are
indifferent.
The characteristics of the receiver relay contacts are given in the
paragraph TECHNICAL CHARACTERISTICS..
The presence of voltage on the receiver is indicated by the Green
Led ON with a fixed light.
