Instruction Manual
Radio control devices T3, T5 and T7 @
2G4
version 1.3 January 14
REM
device
®
- ITALY
page 7 of 28
Self cut-out
When this function is activated (factory setting), the transmitter
switches off automatically after 3 minutes of inactivity. It is restarted
when the START button is pressed.
In self cut-out condition, the equipment still uses a small amount of
energy: to avoid this unnecessary consumption, press the red
Stop/Emergency mushroom button.
Locking and Unlocking the keypad
It is possible to block the use of the transmitter as
follows:
•
supply power to the transmitter by turning and
releasing the red Stop/Emergency mushroom
button
•
press the buttons
1
,
2
,
7
together and
simultaneously the Start button
S
, then release.
If you try to activate the transmitter after this
operation, the Red Led (BATTERY) and the Green
one (ON), blink alternately and the transmitter
emits an acoustic warning.
To unlock the use of the transmitter, repeat the
sequence.
Battery Life
The battery is inside the transmitter. When it is run down, this is
indicated on the transmitter by the regular blinking of the Red Led
(BATTERY).
After the first signal, the radio control device is able to work perfectly
for over 30 hours consecutively.
The working life of the transmitter with a new and fully charged
battery is about 2000 hours (continuous duty).
1
2
3
4
5
6
7
S
Figure 2
Instruction Manual
Radio control devices T3, T5 and T7 @
2G4
version 1.3 January 14
page 8 of 28
REM
device
®
- ITALY
INSTALLATION OF THE RADIO CONTROL DEVICE
REMdevice is at the disposal of installation technicians to supply
useful information that will ensure the correct installation and
commissioning of the radio control device.
Training of personnel
The
installation
of the radio control device on operating machines
must be carried out in compliance with the Machines Directive and
the harmonised regulations. Installation must be performed by
qualified technical personnel, who know the technical characteristics
of the radio control device and of the operating machine, and who
are enabled to compile the document certifying correct installation.
The installer is responsible for any damage to persons or things
resulting from receiver wiring errors, from failure to observe the
safety regulations, from the use of unsuitable material for installing
the receiver, and from non inspection or incomplete inspection of the
radio-controlled machine.
To ensure proper use of the remote control must always be complied
with all applicable regulations on work safety and accident prevention
at work.
Also you should always observe all local laws regarding the use of
the machine and the radio remote control in each country where the
system is used.
Remdevice can not accept any liability if the transmitter is used in
not legal working conditions.
