Reliance electric MD65, Instruction Manual

Page: 123 / 180

Module Parameters
B-5
This parameter is a command. No action is taken if it is set to
“Ready.” Resets the module if it is set to “Reset Module.” Restores
the module to factory default settings if it is set to “Set Defaults.” It
will be reset to “0 = Ready” after the command has been performed.
Sets the action that the module and the drive will take if the module
detects that Ethernet communications have been disrupted. This
setting is effective only if I/O that controls the drive is transmitted
though the module.
17 Reset Module
Range: 0 = Ready (No action)
1 = Reset Module
2 = Set Defaults (Restores module to factory-default
settings)
Default: 0 = Ready
Type: Read/Write
Reset Required: No
!
ATTENTION: If the module is transmitting I/O that
controls the drive, the drive may fault when you reset
the module. Determine how your drive will respond
before resetting a connected module. Failure to
observe this precaution could result in bodily injury
or damage to equipment.
18 Comm Flt Action
Range: 0 = Fault
1 = Stop
2 = Zero Data
3 = Hold Last
4 = Send Flt Cfg
Default: 0 = Fault
Type: Read/Write
Reset Required: No
!
ATTENTION: Comm Flt Action (18) lets you
determine the action the module and connected
drive if communications are disrupted. By default,
this parameter faults the drive. You can set this
parameter so that the drive continues to run. Take
precautions to ensure that the setting of this
parameter does not create a hazard of injury or
equipment damage. Failure to observe this
precaution could result in bodily injury or damage to
equipment.