85
Setup Tool
U
SER
G
UIDE
ONBOARD CONFIG
URATIO
N T
OOLS (S
S
-L)
SMART-S
ENSOR
™
2004 – 2014 Reliable Controls
®
Corporation. All rights reserved.
T
O
USE
THE
SS-L S
ETUP
T
OOL
1
Access the Setup Tool using the appropriate key code combination outlined in
Table 17.
2
ADDR will display the value of the RCP address for the connected controller.
Press the
or
button to select the desired RCP address between 1–124.
Press the
button to scroll to the next parameter.
3
BAUD will display the value of the baud for the connected controller. Press the
or
button to select the desired baud for the network. Press the
button
to scroll to the next parameter.
4
SUBNET will display a value of
Yes
or
No
. The value should display a
Yes
if the
controller resides on a subnetwork. The value should display a
No
if the
controller resides on a main network. Press the
or
button to select the
desired value. Press the
button to scroll to the next parameter.
5
LAST will display a value of
----
or
Last
. The value should display a ---- if the
controller is not the highest physical address on an RCP or BACnet
®
network.
The value should display a
Last
if the controller is the highest physical address
on an RCP network. Press the
or
button to select the desired value. Press
the
button to scroll to the next parameter.
6
BACnet
®
will display a value of
Yes
or
No
. The value should display a
Yes
if the
network communication protocol is BACnet
®
. The value should display a
No
if
the network communication protocol is RCP. Press the
or
button to select
the desired value. Press the
button to scroll to the next parameter.
7
IMPORTANT: UPDATE will display a value of
Yes
or
No
. When the value
displayed is a
No
, any modified configuration parameters are being stored in the
SS-L buffer, and not sent to the controller. Press the
button to send the
configuration parameter settings from the buffer of the SS-L to the controller. To
commit changes to the controller, allow the device to restart and confirm that the
changes have been made, keep the SS-L connected to the device and do not
make any additional changes until the UPDATE value has returned to
No
.
