40
2004 – 2014 Reliable Controls
®
Corporation. All rights reserved.
2
Attach the cover plate to the SS-P.
F
IGURE
35: T
ERMINATE
THE
C
ABLING
FOR
THE
SS-P
The SMART-Sensor
™
is intended to be installed in accordance with the local Electrical Code
for the country and district where it is installed, and in a manner acceptable to the local
authority having jurisdiction.
Ground yourself before touching the device to avoid damaging the electronics. Touch a
grounded metal surface to discharge static electricity.
Do not use conductors larger than 24 AWG (0.25 mm
2
) to facilitate the proper installation of
an RJ11 modular connector at the host controller.
Do not mount the SS above, or on the surface of heat-producing sources, below cooling
sources, near windows, behind obstructions, or in areas prone to infiltration. When mounted
in or on hollow walls, ensure that the electrical box and penetration is insulated and/or the
backplate is mounted to an insulated subbase to prevent drafts external to the space from
influencing the onboard thermistor.
RJ11 connectors for stranded and solid core conductors are not interchangeable. Using
the wrong connector will cause intermittent communication. The appropriate connector for
stranded conductors will have teeth on the gold plates that pierce the wire (this can be seen
by looking at the side of the connector closely). Connectors for solid core wires have a
single jaw that wraps around the solid conductor.
Gnd
Clk
+5
Data
