Reiner 880, Service Manual

Page: 83 / 102

service
Troubleshooting
9
880
Ausgabe:
888950 - 001 - A
9-1
9 Troubleshooting
Faults can be classified into those which are accompanied by an error message and those
without an error message.
9.1 Faults with an error message
5
9.1.1 Messages
Display Cause Remedy
Empty batteries
Please exchange
Battery voltage too low
Battery box is
empty
Battery compartment is empty
Press OK button,
(message appears only once a day)
Please wait
Reference run Mo-DKA, when cover
has been replaced
Wait ca. 1s until reference run Mo-DKA
has finished
Insert Chipcard No chipcard in chipcard reader Insert chipcard into reader slot
Chipcard Line 2
ignored
The chipcard has a second line.
This cannot be processed by the 880.
Press OK button.
Line 1 will be shown in display, ma-
chine is ready to stamp.
After Test (49),
Reset Mo- DKA
Ending of sensor test on 880:
(results from either pressing the «Back»
button or from closing the sensor test
on the PC = 880 PC Setup Module)
Press OK button.
A reference run Mo-DKA will be carried
out
9.1.2 Warnings
Display Cause Remedy
Warning 01
FLASH has been overwritten with de-
fault settings.
Press OK button
Warning 02 Impression number set is invalid.
Press Menu button
Enter valid impression number in menu
Warning 04
Flash memory write operation not suc-
cessful
(EEPROM error)
Press OK button.
Warning 05
Wrong typeface
Wrong typeface configured.
Press OK button.
Error message disappears and previ-
ous display reappears.
5
Source: PC 889035-000- B