Reiner 880, Service Manual

Page: 85 / 102

service
Troubleshooting
9
880
Ausgabe:
888950 - 001 - A
9-3
Display Cause Remedy
Prog.no. > 0 not
OK
greater than 0 card.
Warning 24
Chipcard is
empty
Chipcard is empty and impression no.
is 0 (when impression no. is 0, this
card is accepted as key)
Remove chipcard and change impres-
sion design.
Warning 31
Replace cover
Cover has been removed. Replace cover
9.1.3 Machine faults
Display Cause Remedy
Device error 59 32kHz quartz has NOT started
Replace control board
(Section 7.3.4 Replacing control board
880 cpte. )
Device error 73
Print operation Mo- DKA:
photocell L-DKP not reached
- Check cycle station Mo-DKA, if defec-
tive replace upper part
(Section 7.3.5 Replacing the upper
part)
- Check photocell L-DKP, if defective
replace needle driver
(Section 7.3.6 Replacing the needle
driver 880)
Device error 77
Print operation Mo- DKA:
Mo- DKA has not reached initial posi-
tion
- Check Mo-DKA cycle station
- Check crank
- Check L-DKP on needle driver
If a defect is found, replace the relevant
component or sub-assembly.
Device error 59 32kHz quartz has NOT started
Replace control board
(Section 7.3.4 Replacing control board
880 cpte. )
Device error 118 Mo-DWA position P3 not reached
Check cycle station Mo-DWA
Check photocell L-DWP
Device error 119 Mo-DKA position L-DKP not reached Check photocell L-DKP