Reich Kupplungen MMS-T W Series, Operating Instructions Manual

Page: 34 / 52

Mounting the coupling
34
Proceed as follows to engage the coupling halves with each other:
Loosen and remove the bolts (1) from the retaining cap (2).
Slide back the retaining cap.
Move the driven machine or the drive unit until the claws of the two coupling halves
are in engagement.
Ensure that gap S1 is observed, see page 36.
If necessary, correct the distance by moving the units.
Securely fasten the driven machine and the drive unit in this position.
Make sure that all saddle elements are available and mounted or that the toothed
ring is available and mounted.
Slip the retaining cap over the coupling hub.
Fix the retaining cap into position with the bolts.
Tighten the bolts crosswise with the necessary torque, see page 32.
Mark the bolts which have been tightened to the required torque in colour.