Safety information
12
The FOCUS.ARC P MIG/MAG gas welding equipment has been subjected to a
safety test and acceptance. In the event of incorrect operation or misuse, there is
a danger to
•
life and limb of the operator,
•
the machine and other material assets of the operator
•
the efficient work of the machine
All persons involved in the installation, commissioning, operation, maintenance
and repair of the machine must
•
be appropriately qualified
•
strictly observe these operating instructions.
Your safety is at stake!
FOCUS.ARC P MIG/MAG gas welding equipment should be operated only by
persons who are trained and instructed in the use and maintenance of welding
equipment. Only qualified, assigned and
trained personnel may work on and with
the system.
The operator is responsible for third parties in the work area. The responsibility
for this machine must be precisely defined and adhered to. Unclear
responsibilities are a safety risk.
The operating company must
•
make the operating instructions accessible to the operator and
•
ensure that the operator has read and understood them.
Connect a lockable switch in front of the machine to prevent unauthorised
operation.
These operating instructions contain important information on how this unit can
be operated safely, properly and economically. A copy of the operating
instructions must be constantly at hand in a suitable place at the site of use of the
system. Before using the system be sure to read the information compiled in
these operating instructions. These include important instructions on use of the
equipment that enable the full technical advantages of the RHEM equipment to
be exploited. See also the information on repair and maintenance, operating
safety and functional reliability.
These operating instructions are not a substitute for the practical teaching by the
REHM service personnel.
Documentation for any additional operation that may be present must also be
observed.
Changes to the system or the mounting or incorporation of additional equipment
is not permitted. Doing so will invalidate any warranty and liability claims.
Third-party intervention and putting out of operation of safety devices invalidates
all warranty claims.
High power units can affect the mains voltage due to their high power
consumption. Therefore, connection restrictions, requirements for a maximum
permissible mains impedance or requirements for a minimum necessary
available power at the connection point to the general mains supply may exist for
certain unit types (see technical data). If this is the case, the user of a unit - after
consulting the power supplier if necessary - must ensure that the unit may be
connected.
Purpose of the
document
Changes to
the system
Requirements on
the mains supply
Qualification of the
operating
personnel
Dangerous nature
of this machine
Summary of Contents for FOCUS.ARC P 250
