27
HD Motion
|
Technical Information
3.8 Leg rests
HD Motion can be equipped with two
types of leg rest, see Figure 34.
A
. Centre leg rest
B
. Separate leg rests
The leg rests consist of these
components:
• Leg rest mount
• Leg rest tubes
• Footrest
• Calf support (optional)
3.8.1 Leg rest mount
Both types of leg rest have a leg rest mount that docks in
the seat frame and is secured with screws (2 in Figure 35).
The depth position of the leg rests can be adjusted with the
different holes in the telescoping rods (1 in Figure 35).
NOTE
: Always use the original screw (2) as it has a special
washer attached to protect the seat frame from damage.
Note: The leg rest mounts differ between sw30 and sw34.
A
. The centre leg rest mount is somewhat flexible in width
which makes it easier to fit the telescoping rods into the
seat frame when assembling.
The mount can be angled to different positions and locks
in place with a spring-loaded pin.
See Spare Parts list page D1.5 for detailed information.
B
. The separate leg rests mount is not flexible. To make initial
assembly to the seat frame easier follow these steps:
1. Loosen the screws (Figure 36) a few turns. The width
between the rods can then be adjusted slightly.
2. Insert the leg rest mount to the desired depth.
3. Secure with screws (2 in Figure 35)
4. Tighten the screws from step 1 (Figure 36).
The width adjustment is only needed the first time the leg
rest mount is assembled to the seat frame.
The separate leg rest mount is fixed, angle adjustment of the
leg rests is done with the leg rest tubes.
See Spare Parts list page D1.5 for detailed information.
Figur 34.
Benstöd Delat och Benstöd Center
Figur 35.
Benstödsinfästning
Figur 36.
Benstödsfäste delat
breddjusteringsskruv
1
2