28
HD Motion
|
Technical Information
3.8.2 Leg rest tubes
A
. Centre leg rest tubes
The leg rest tubes are attached to the centre stay with 2 screws each
(Figure 37). Tubes come in 3 lengths and include a snap-lock for
attaching a footrest. Note: Tubes are the same for sw30 and sw34.
Replacing leg rest tubes:
1. First remove the footrest and any calf supports.
2. Remove the screws (Figure 37) and remove off the tube.
3. Assemble the new tube and fasten the screws but do not
tighten at this point.
4. Mount the footrest and check that the foot rest tubes
telescope smoothly on the leg rest tubes.
5. Tighten the screws.
See Spare Parts list page D1.5 for detailed information. For
measurements and settings refer to Info Sheet 96901-1.
B
. Separate leg rest tubes
Each leg rest tube consists of a joint block and a tube. The
leg rest tube has a button for quick release from the leg rest
mount. It can be angled to different positions and locks in
place with a spring-loaded pin. The complete leg rest tube
with joint block can be replaced, or the tube can be replaced
separately.
Note: with separate leg rests it is possible to have different leg
rest tube lengths on each side.
Replacement of leg rest tube:
1. First remove the footrest and any calf support.
2. Remove the screws (Figure 38) and take the tube out of
the joint block.
3. Place the new tube in the joint block and screw in place.
See Spare Parts list page D1.3 for detailed information. For
measurements and settings refer to Info Sheet 96902-1.
3.8.3 Footrests
A
. One-piece footrest (Centre leg rest)
The footrest consists of a foot plate mount, an aluminium foot
plate, and polyurethane (PUR) cover. The foot plate is riveted to
the foot plate mount.
The rubber cover is easily replaced. The foot plate has holes and
slots for foot straps. Slots can be cut in the cover with a knife, or
the cover can be ordered with slots pre-cut from HD Rehab.
The footrest plate can be folded up. The friction when folding up
can be adjusted by tightening the nut on the mount (Figure 39).
Note: The footrest differs between sw30 and sw34.
See Spare Parts list page D3.2 for detailed information. For
measurements and settings refer to Info Sheet 96901-1.
Figure 37. Center leg rest -
Screws for leg rest tubes
Figure 38. Separate leg rests -
Screws for leg rest tubes
Figure 39. Nut for folding of
foot plate
