23
HD Motion
|
Technical Information
3.3.4 Adjustment of cable
Adjustment of brake cables is done per sections 3.1.1 and 3.2.1.
Adjust cables for seat tilt and back recline as follows:
1. First identify where the adjustment screw is under the back frame. See
Figure 19.
NOTE
: The adjustment screw for the seat tilt lever on the
right
side of the push bar is found on the
left
side of the wheelchair, and vice
versa for the back recline lever.
2. Loosen the nut (2 in Figure 24) on the adjustment screw and screw the
sleeve (1) in or out to the correct adjustment.
3. Tighten the nut.
NOTE
: There should always be some play in the lever so that the gas spring is
never released unintentionally. The gas spring should release when the lever
is fully depressed.
3.4 Push bar
3.4.1 Replacement of push bar
1. Remove the screws (Figure 20) to release the
cable controls on both sides of the push bar.
2. Remove the screws from the angle joint (1 in
Figure 25) on both sides, pull the push bar out.
3. Assemble the new push bar and put the controls
back in place in the same manner.
4. Check that all cables are routed and clipped in
place correctly, see section 3.3.1.
5. Test the braking function and adjust cables as
necessary per section 3.1.1. Also check seat tilt
and back recline function and angle adjustment
of the push bar.
3.4.2 Replacement of angle joint
1. Remove the screws from the angle joint (1 in
Figure 25) on both sides.
2. Carefully pull the push bar out, watch that no
cables are damaged.
3. Remove the screws from the back frame (2) and
pull out the angle joints on each side.
4. Assemble the new angle joints and re-assemble
the push bar following steps 1-3 in reverse order.
5. Check that all cables are routed and clipped in
place correctly, see section 3.3.1.
6. Test the braking function and adjust cables as
necessary per section 3.1.1. Also check seat tilt
and back recline function and angle adjustment
of the push bar.
Figur 25.
Skruvar till körbygel
Figur 24.
Justerskruv
1
1
2
2
2
1
