│
6
Regulus CSE2 MIX F W 1F - www.regulus.eu
TROUBLESHOOTING, RESTART, FACTORY SETTINGS
If air is present in the pump:
Activate the pump venting function by pressing and holding the
operating button for 3 sec. The upper and lower rows of LEDs will
flash in 1sec interval, see Fig.
Pump venting takes 10 minutes, after that the pump returns to
current mode. In order to cancel pump venting, press and hold the
operating button for 3 sec.
Operating button locking/unlocking
To lock the operating button, press it for 8 seconds.
The selected setting then starts flashing and cannot be changed.
To unlock, hold down the operating button again for 8 seconds
and the LEDs will stop flashing.
Manual restart
If the pump has been inactive for a long time or is blocked, activate
the manual restart by holding the operating button for 5 seconds.
The LEDs flash sequentially clockwise. The manual restart takes
max. 10 minutes before the pump returns to normal operation. To
cancel the manual restart, hold down the operating button for 5
seconds.
If the pump does not get unblocked, contact a qualified technician.
Factory settings
To return to the factory settings, press and hold the operating button for at least 4
seconds (all LEDs flash for 1 second) and turn off the pump by unplugging. When
switched on again, the pump will run at the factory settings.
sec
3
min
10
sec
8
sec
5
min
10
