3. If user is calling a Skype contact with a voice mail on-going, the call
can't be reserved and user can press
“
*”
key to disconnect the call.
4.10.1 Make a Multi-Call
1. When a Skype call is undergoing, pressing the Multi-Call function
key “
*
1
”
will put the current Skype call on hold. There will be a dial tone to inform user
it is time to add another Skype contact by dialing the speed dial number
(
followed by “#” key for an immediate call). The same procedure can be
repeated until the maximum of 4 Skype contacts have been added.
2. User can also use the Skype window interface to make a Multi-Call. Then
pick up the phone receiver and wait for the contacts to proceed with the call.
3. When there are more than two Skype users in a Multi-Call, user might hear a
busy tone for 5 seconds if the Skype contact doesn’t answer the call or hang
up during conversation. Then a Skype dial tone comes up and user can
decide to add a new contact or press “
*
1” keys to switch to the reserved call.
However, there won’t be busy tone played if the reserved contacts hang up.
4. When user presses Multi-
Call function key “
*
1”, user needs to press key “1”
after key “
*
” within 3 seconds. Otherwise the current call will be hung up and
won’t be reserved.
4.10.2 Switch calls in a Multi-Call
To switch between the Skype multiple contacts, press the Multi-Call function key
“
*
1
”. There will be a dial tone coming up. Press the Multi-Call function key “
*
1
”
again after hearing the dial tone. Then the Skype call is switched to the next
reserved Skype contact. The previous call will be put on hold. The sequence of
the switch circulation is the same as the sequence these calls were established.
For example, user sets up call 1 to call 5. When user talks to call 5 and next
switch will be call 1.