LRI3E / HRI3E Direct Vent Gas Insert
|
37
|
37
maintenance
WARNING: CHILDREN AND ADULTS
SHOULD BE ALERTED TO THE HAZARDS
OF HIGH SURFACE TEMPERATURE AND
SHOULD STAY AWAY TO AVOID BURNS
OR CLOTHING IGNITION. YOUNG
CHILDREN SHOULD BE CAREFULLY
SUPERVISED WHEN THEY ARE IN THE
SAME ROOM AS THE APPLIANCE.
MAINTENANCE
INSTRUCTIONS
1) Always turn the gas valve to off before cleaning.
For relighting, refer to lighting instructions. Keep
the burner and control compartment clean by
brushing and vacuuming at least once a year.
When cleaning the logs, use a clean soft paint
brush as the logs are fragile and easily damaged.
2) Clean (never when unit is hot) appliance with a
damp cloth. Never use an abrasive cleaner.
The heater is inished in a heat resistant paint
and should only be reinished with heat resis-
tant paint (not with wall paint). Regency uses
StoveBrite Paint - Metallic Black #6309.
3) Make a periodic check of burner for proper posi-
tion and condition. Visually check the lame of
the burner periodically, making sure the lames
are steady; not lifting or loating. If there is a
problem, call a qualiied service person.
4) The appliance and venting system must be
inspected before use, and at least annually, by
a qualiied ield service person, to ensure that
the low of combustion and ventilation air is not
obstructed.
During the annual service call, the burners should
be removed from the burner tray and cleaned.
Replace the embers but do not block the pilot.
5) Keep the area near the appliance clear and free
from combustible materials, gasoline and other
lammable vapours and liquids
6) Each time the appliance is lit, it may cause con-
densation and fog the glass. This condensation
and fog is normal and will disappear in a few
minutes as the glass heats up.
Never operate the appliance without the glass
properly secured in place or with the door open.
7) Do not use this appliance if any part has been
under water. Immediately call a qualiied service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
8) Periodically check the pilot lames. Correct lame
pattern has two strong blue lames: 1 lowing
around the lame sensor, and 1 lowing across
the burner (it does not have to be touching
the burner).
9) Proper reassembly and resealing of the vent
air intake system must be completed when
servicing the appliance. See lue/vent installation
instructions in this manual on proper procedure
to remove, seal and reattach the vent system.
Never leave the vent system detached from the
appliance.
DOOR GLASS
Your Regency insert is supplied with high
temperature, Neoceram ceramic glass that will
withstand the highest heat that your unit will produce.
If your glass requires cleaning, we recommend
using an approved glass cleaner available at all
authorized dealers. Do not use abrasive materials.
Do not clean the glass when hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency dealer only, and follow our step-by-step
instructions for replacement.
Door Components
Window Glass
Window Glass Gasket
Door Frame
Window Clip (x4)
Warning: Do not operate appliance
with glass panels removed, cracked
or broken. Replacement of the glass
should be done by a licensed or
qualiied service person.
CAUTION & WARNINGS:
* Do not clean when the glass is hot.
* The use of substitute glass will void all product
warranties.
* Care must be taken to avoid breakage of the
glass.
* Do not strike or abuse the glass.
* Do not operate this ireplace without the glass
front or with a cracked or broken glass front.
* Wear gloves when removing damaged or broken
glass.
* Replacement of the glass panel(s) should be
done by a licensed or qualiied service person.
GLASS REPLACEMENT
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency® dealer only.
Replacement Neoceram glass (Part # 940-454/P)
is shipped with a gasket.
CAUTION: ANY SAFETY SCREEN OR
GUARD REMOVED FOR SERVICING AN
APPLIANCE MUST BE REPLACED PRIOR
TO OPERATING THE APPLIANCE.
CLOTHING OR OTHER FLAMMABLE
MATERIAL SHOULD NOT BE PLACED
ON OR NEAR THE APPLIANCE.
Summary of Contents for liberty LRI3E
