Regency Bellavista™ B36XT Gas Fireplace
17
INSTALLATION
7) From the outside top of the fi rebox -
remove the intake cover plate
by removing the 4 - 1/4" x 1/2 " screws. See Diagram 7.
6) From the outside top of the fi rebox -
remove top insulation cover
plate and insulation fi lling - by removing 4 screws. See Diagram 6.
Discard cover plate and insulation fi lling.
5) From the outside rear of the fi rebox,
remove the intake collar
assembly. Remove the 4 - 1/4" x 1/2" screws. See Diagram 5.
Diagram 5
Exhaust
Assembly
Intake Collar
Assembly
Diagram7
Diagram 6
Before proceeding to Step 8
, inspect condition of all gaskets.
DO NOT install parts with damaged gaskets. Replace if necessary
with spare gaskets supplied.
8)
From the inside of the fi rebox,
place the exhaust assembly into
position as shown in Diagram 8 and secure with 8 - 1/4" x 1/2" screws
(Diagram 9). Ensure all screws are tight, but do not over tighten.
All 8 screws must be used.
Diagram 8
Diagram 9
10)
From the outside rear of the fi rebox,
install the intake cover plate with
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
11)
Set vent restrictor accordingly - see next page.
12) From inside the fi rebox,
re-install the baffl e plate and heat
defl ector - reverse steps 2 & 3.
9)
From the outside top of the fi rebox
, install the intake collar assembly.
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten. All 4 screws must be used.
Diagram 11
Intake Collar
Assembly
Exhaust
Assembly
Diagram 10
13) From inside the fi rebox
, reinstall the top heat defl ector by placing 2 screws.
Heat Defl ector
Diagram 2
14) From inside the fi rebox
, reinstall the baffl e plate by placing 4 screws
- replace top front screw fi rst. Leave loose - until rear screws installed.
See Diagram 3.
Baffl e Plate
Diagram 3
Note
: Reuse existing screw holes - do not make new holes. Tighten screws.
