Regency Fireplace Products Horizon HZ40E, Owners & Installation Manual

Page: 56 / 80

56
|
Regency Horizon® HZ40E-11 Gas Fireplace
installation
Inner Panel Installation
919-076a
05/17/12
1) Remove the faceplate and glass door if already installed - see
manual for instructions.
2) Remove 4 screws to remove top heat defl ector.
7) Install the left side enamel panel - secure in position with the panel clip
and tighten two screws loosened in step 3 as shown in the diagram
below.
8) Install the right side enamel panel - secure in position with the panel
clip and two screws loosened in step 4.
9)
Reinstall heat defl ector.
10)
Reinstall glass door - reinstall faceplate.
4)
Repeat on opposite side.
5)
Remove back panel.
6)
Install the back enamel panel fi rst. Tilt the panel forward - position
the bottom of the panel fi rst. Use care not to scratch or mark the
panel on the pilot shield.
Final Install
3)
Remove installed factory panels.
Loosen 2 screws (do not remove) on panel clip securing side panel,
Slide panel clip down away from screws.
Remove side panel.
Handling Instructions
Black Enamel Panels
•
Black Enamel panels must be inspected for scratches and dimples
prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
*All hand and fi nger marks MUST be cleaned off with a soft cloth.
Use an ammonia based cleaner (ie. glass cleaner) to remove any
fi ngerprints before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will
be unable to remove.
Not protected by product warranty.
Panel clip
1
HZ40E
INNER PANEL INSTALLATION