22
18. Pairing function
For the sender and receiver to work together, they must be paired together with the same digital coding. When deliv-
ered, the transmitter and receiver are paired and can be used immediately. Renewing the pairing setting is required
primarily after a change of transmitter or receiver or to correct for interference.
Before pairing the receiver with the transmitter, check whether the transmitter works in the correct digital coding (see
the previous chapter).
To perform the pairing function, proceed as follows:
•
Transmitter and receiver must be in the immediate vicinity (about 50 cm distance).
•
Switch off the transmitter.
•
Disconnect any connected servos from the receiver.
•
Connect the enclosed programming plug (18) to the
BIND/VCC connector of the receiver.
•
The power supply of the receiver (receiver battery or
speed controller with BEC) is connected to output CH3
of the receiver.
•
Turn on the receiver. The LED in the receiver (16) starts
flashing quickly.
•
Press the pairing button on the transmitter (see Figure
2, Pos. 14) and hold it down.
•
Turn on the transmitter while holding the button. The low
voltage indicator on the transmitter flashes.
• When the LED in the receiver (2) flashes slowly after a
few seconds, the pairing process is completed.
•
Release the pairing button on the transmitter.
•
Turn off the receiver and the transmitter and remove the programming connector.
•
Reconnect the servos/controllers to the receiver.
•
Check the function of the system. If the system does not work properly, perform the procedure again or check the
digital coding of the transmitter.
If you have switched the transmitter to AFHDS digital coding and pair with an AFHDS receiver, the LED in
the receiver will not flash slowly after pairing, but will light up solidly.
Figure 16
