17
If the wheels turn in exactly the opposite direction as
shown in Figure 11, you can use the reverse switch for
the steering function (15) to switch the effective direction
of the steering wheel and thus the direction of rotation of
the steering servo.
It may then be necessary to set the steering
trim again.
Important!
Set the linkage rods on your model so that the full steering deflection to the left and right is achieved without
any mechanical impact or limitation on the steering.
If the steering deflection is too large when operating the model, it can be reduced by means of the dual rate
buttons for the steering function (see Figure 12, Pos. 9).
If you press and hold the lower button (-), the green LED will flicker and the maximum possible steering deflection will
be reduced. If the upper button is pressed and held, the steering deflection increases again. If you turn the control
wheel on the transmitter fully to the side during setting, the setting change can be easily observed.
The setting of the maximum steering deflection affects both steering directions simultaneously. The set value is stored
automatically and remains even after switching the remote control off and on again.
Figure 12