21
17. Switching the digital coding
Your remote control transmitter provides the option of controlling receivers with AFHDS and AFHDS2A digital coding.
The transmitter is factory-set to the enclosed AFHDS2A-coded receiver.
If you want to operate a REELY receiver with AFHDS digital coding, the transmitter must first be changed over and
then the receiver must be connected to the transmitter (see following chapter).
To switch the digital coding on the transmitter, proceed as follows.
•
Switch off the transmitter.
•
Move the steering wheel for the steering function (see Figure 1, Pos. 2) to one side until it stops and hold it in place.
•
Press and hold the pairing button (see Figure 2, Pos. 14).
•
With the steering wheel in the steering position and the pairing button pressed, switch on the transmitter with the
on/off switch.
•
Release the steering wheel and the pairing button.
• If the green LED for the low voltage indicator is flashing continuously, the transmitter has switched to the AFHDS
digital coding.
If the green LED flashes intermittently, the transmitter has switched to AFHDS2A digital coding.
•
Pressing the pairing button again will save the currently set digital coding.
•
Turn the transmitter off and then on again to have the remote control transmit in the set digital coding.
Important:
The receiver supplied with the "GT2+1 EVO" remote control system works with AFHDS2A digital coding.
Therefore, always make sure to program the correct coding on the transmitter!
