16
9. Remote control buttons
Figure 4
1 Smartphone holder
2 Antennas
3 On/off switch with LED indicator
4 "Return and landing at the starting point" button
5 "Flight mode" button
6 Left-hand control lever (rise/fall and yaw)
7 "Pan camera up" button
8 "Calibrate gyro" button
9 "Pan camera down" button
10 "Calibrate compass" button
11 "Auto start/landing" button
12 "Turn GPS on and off" button
13 Right-hand control lever (roll and pitch)
14 "Headless mode" button
The smartphone holder (1) is already installed and shown in Figure 4. A smartphone up to 82 mm wide can
be attached here.
The holder is mounted from above by sliding it into the bracket on the transmitter until it clicks into place. The smart-
phone holder (1) can be disassembled again by sliding the bracket assembly out of the transmitter. To do this, press
the grooved surface on the back of the transmitter above the battery compartment cover and push the bracket up-
wards. The smartphone holder can then be detached from the transmitter bracket and removed.
