10
10. Setting up the Transmitter
In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries
For the power supply of the transmitter you will need
4 alkaline batteries (e.g. Conrad item no. 652507, pack
of 4, order 1x) of the size AA/mignon.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of
the transmitter. Press the corrugated area (2) and push
off the lid downwards.
Ensure that the polarity is correct when inserting the
4 batteries. A corresponding note (3) is located on the
bottom of the battery compartment.
Then slide the lid of the battery compartment back on
from the bottom until the locking mechanism engages.
b) Switching on the Transmitter
When new batteries are inserted, switch on the transmit-
ter with the function switch (see figure 1, item 10) for test
purposes. For this, slide the operating switch from the
bottom (off) to the top (on).
The transmitter emits a short signal sound and the LED
display (also see figure 1, item 9) lights up green per
-
manently.
If the voltage supply drops below 5 V, the LED display
switches from green to orange to red and thus indicates
threatening undersupply of the transmitter. The model
should then no longer be operated.
When the voltage drops below 4.2 V, the LED display
starts flashing red and the transmitter emits acoustic
warning sounds at regular intervals. In this case, opera-
tion of the model must be ceased as quickly as possible. Insert new batteries for further operation of the transmitter.
After you have verified the correct function of your transmitter, switch it off again.
Figure 2
Figure 3
