8
5
6
6. Insert the Main Wire Harness (89) and the Upper
Wire Harness (41) upward through the indicated
opening in the Handlebar (6).
6
6
4
70
70
67
41
89
67
5.
Make sure that the Main Wire Harness (89)
and the Upper Wire Harness (41) are in the
location shown.
Using a small plastic bag to keep your fingers
clean, apply a coat of the included grease to an
M6 x 70mm Bolt Set (67).
Tip: Avoid pinching the wires.
Attach the
Handlebar (6) to the Upright (4) with the M6 x
70mm Bolt Set (67) and two M8 Washers (70).
Then, attach an M6 x 60mm Bolt Set (68)
through the bracket on the Handlebar (6).
Make
sure that the Bolt Set is inside the bracket.
Avoid pinching
the wires
Grease
Bracket
68
68
89
41
