- 4 -
- 5 -
ENGLISH
FRANÇAIS
DEUTSCH
IT
ALIANO
ESP
AÑOL
4-2
Creep Zone Detection Area Setting
Adjust the creep zone horizontally.
The creep zone detection area can be adjusted between
-90° and 90° horizontally.
-90°
+90°
[m]
0
5
5
50
50
40
5
0
5
0
[ft.]
30
20
0
0
0
20
30
40
Adjust the creep zone vertically.
The creep zone detection area can be adjusted between -3°
and 3° vertically.
-3°
+3°
[m]
2
0
[ft.]
0
0
4
3.2
0
0
0
0
20
30 [ft.]
[m]
()
(2)
Connect the walk tester (optional) to the sensor unit, and
check that the detection area is correct.
REDWAVE
REDWAVE
MICROWAVE
REDWAVE
ALARM OUTPUT
CELL BATTERY
POWER
SUPPLY
FROM
SENSOR
POWER OFF
REDWAVE
PIR NEAR
REDWAVE
PIR FAR
MEGARED
FAR
MEGARED
NEAR
REDWALL
REDWIDE
WALKTESTER
REDWALL
REDWIDE
MEGARED
CONNECTION
SELECT
SWITCH
MODE
SELECT
SWITCH
POWER
SELECT
SWITCH
OPM-WT
1
When the power selector switch is turned to “POWER
SUPPLY FROM SENSOR” position after plugging
the cable into the walk tester connector, a continuous
beeping sound will be heard.
2
When a pedestrian first enters the detection area, the
strong and weak beeps will sound alternately.
3
When the entirety of a pedestrian’s body is detected,
the strong beep will sound continuously.
Cautions>>
When you are checking the detection area, take care not
to cover the shaded area of the window with the walk
tester or its cable. If infrared beams to the sensor are
partially shielded, the detection sensitivity will drop and
the detection operation may fail.
If it is difficult to detect an object>>
. Set the detection logic switch to the “OR” position (see Step 5-2).
If the sensor is OK when you have completed the walk
test, return the logic switch to the “AND” position.
2. Adjust the sensor sensitivity switch (see Step 5-).
To mask the detection area>>
Detection
area
How to mask the area
Reference
SIP-5030
SIP-00
Far area
Attach the masking seal
(an accessory) to the area
mirror surface.
Far area
cannot be
masked.
Step 7
Near
area
Use the masking plate
(mounted in the main
unit).
Near area
cannot be
masked.
Step 8-
Attach the masking
seal (an accessory)
to the area mirror
surface.
Step 8-2
* Creep zone cannot be masked.
(3)
Creep zone
adjustment guides
If you want to
adjust the creep
zone at the angle
of 0°, align these
guides.
Detection area at -3° adjusted.
Detection area at +3° adjusted.
Gently press to move
upward
Gently press to move
downward
For near area alarm output
For far area alarm output
Use at “REDWAVE ALARM
OUTPUT” position to
confirm far and near area
alarm output.
Power selector
switch
Use at “REDWALL” position.
For creep zone alarm output
SIP5030_EN.indd 5
2009/03/18 9:28:34
