M003 Issue: 1.5 Created by: Technical Dept.
7
February 2020
10.0
Programming the Lightbar
10.1
Setting an Input Function
Nine inputs
(F1-F9)
can each be programmed to perform 23 optional functions
a)
Connect all the input wires to the LBAR Main Controller (
refer to section 4.0
)
b)
E
nsure that the Lightbar is in ‘Standby’ mode by connecting
Red
+ve
Black
-ve
c)
Apply the yellow
(sync)
wire to
-ve permanently
d)
Apply the
brown
(Pattern Select)
wire to +ve permanently for
5 seconds,
diagnostic
LED will display 4 short flashes
–
do not proceed to next stage without this ‘pause’
e)
Apply the required input wire individually (
F1-F9
) to +ve permanently
f)
Apply the grey wire
(Config)
momentarily to +ve to cycle through to the required
function. Diagnostic LED will flash to confirm the function has been selected
(refer to
Appendix 2)
g)
Release the
brown
and yellow wire
h)
The F1-F9 input is now programmed to the desired function
i)
Simply repeat the process until all the F1-F9 inputs have been programmed
Input Function
Feature
Code
Default
Selectable Function
360 O/P 2
1
F4
Flash Entire Bar (Rear off as standard)
Colour
2
F9
Programme Colour
Left
3
F1
Main Traffic Director Left
Right
4
F2
Main Traffic Director Right
Centre
5
F3
Main Traffic Director Centre
Rotate
6
F6
Rotate Ends
Front Only
7
Flash Front Only
Rear Only
8
F5
Flash Rear Only
Cruise Mode
9
Glow Ends (Cruise Mode)
FF1
Front Flood Flash
10
Selected LED's Flash starting in front position (can also be made to steady burn)
FF2
Front Floods
11
Selected LED's Permanent On starting in front position (can also be made to flash)
FF3
Flexi-Flash
12
Selected LED's Flash starting in rear position (can also be made to steady burn)
Alley Left
13
F7
Alley Left
Alley Right
14
F8
Alley Right
Stop Light
15
Stop Light, Full Then 50% Brightness
Tail Light
16
Stop Light 25% Brightness
Indicator Left
17
Indicator Left
Indicator Right
18
Indicator Right
Left Front
19
Front Traffic Director Left
Right Front
20
Front Traffic Director Right
Centre Front
21
Front Traffic Director Centre
Rear Worklamp
22
Steady Work Light Rear
360° Worklamp
23
Steady Work Light All-Round
10.2
To reset an input to the first function in the list
(360 O/P 2 - Flash entire bar)
a)
Apply the yellow
(sync)
wire to
-ve permanently
b)
Apply the
brown
wire to +ve permanently
c)
Apply the required input
wire to +ve permanently
d)
Apply the grey wire to +ve for two (2) seconds
e)
Release the
brown
and yellow wire
f)
Input is now set to the first function
