M003 Issue: 1.5 Created by: Technical Dept.
17
February 2020
f)
With the new LED modules in position, carefully replace the top lenses and secure using
the M4 and M6 socket cap screws and washers -
All fixings must be inserted with a
torque setting of 1.8Nm (18.4Kg/cm, 15.9in/lbs, 1.33ft/lbs)
g)
Reconnect to the vehicle battery
h)
Refer to 10.0 Programming the Lightbar
i)
For Dual and Multi-Colour Lightbars refer to 9.0 Setting the Colour
13.2
Adding Alley Light modules (EM315WC/BL (internal stock code S.EM315WC/BL)
a)
Carefully remove the M4 and M6 socket cap screws and washers from the top lenses
and place to one side
b)
Remove the top lenses and place carefully to one side. Ensure that the silicone rubber
seals remain in place within the base lenses
c)
Position the Alley Light(s) into the base lens end section, ensuring it is seated correctly
(Fig. 1)
d)
Connect the 2-core cable for each Alley Light to the LBAR Main Controller
(Fig. 2)
e)
With the Alley Lights in position, carefully replace the top lenses and secure using the
M4 and M6 socket cap screws and washers
- All fixings must be inserted with a torque
setting of 1.8Nm (18.4Kg/cm, 15.9in/lbs, 1.33ft/lbs)
Fig. 1