M003 Issue: 1.5 Created by: Technical Dept.
5
February 2020
5.2
Alley Lights
–
‘
Permanent on
’ or ‘Flash’
a)
Ensure the Lightbar is in ‘Standby’ mode
by connecting
Red
+ve
Black
-ve
b)
Apply the Alley Left & Alley Right input wires to +ve permanently
c)
Apply the
brown
(Pattern Select)
wire to +ve momentarily
d)
The Alley Lights will now flash in an alternating pattern
e)
To Revert to ‘Permanent on’ apply the
brown
(Pattern Select)
wire to +ve momentarily
f)
If wanting to use more than ‘alley light’
for illumination, simply Apply the grey
(Config)
wire to +ve permanently
a)
Apply the
brown
(Pattern Select)
wire to +ve momentarily
b)
Release the grey wire
Note: Changing Alley Light
s to ‘Flash’
will not affect the pattern of the lightbar when it is
not selected
6.0
CAP168 / ICAO / CAA / ACAA (whilst in 360/1, 360/2, Cruise Mode, Rotate patterns) -
(61fpm)
This function is built-in to the Cruise and Rotate flash patterns as standard. If you require it
on another wire, setting Dil Switch 2 to
‘ON’
gives the addition of CAP168 pattern
(Airport
Mode)
to the 360/1, 360/2 flash pattern options
–
in all 4 different flash modes (
left-right,
all-on, mix, in-out
). In addition, the colour can be individually set to each output
(refer to 9.0
Setting the Colour)
6.1
360/1 & 360/2 Outputs
a)
Ensure the Lightbar is
in ‘Standby’ mode, set Dil Switch 2 to
‘ON’
b)
Apply the input wire programmed as
‘360/2’
to +ve permanently
c)
Apply the
brown
(Pattern Select)
wire to +ve momentarily until CAP168 is enabled
6.2
Cruise Mode
a)
Apply the input wire programmed as
‘Cruise Mode’
to +ve permanently
b)
Apply the
brown
(Pattern Select)
wire to +ve momentarily until CAP168 is enabled
6.3
Rotate
a)
Apply the input wire programmed as
‘Rotate’
to +ve permanently
b)
Apply the
brown
(Pattern Select)
wire to +ve momentarily until CAP168 is enabled
7.0
Setting Dim Mode
There are two modes available with the Lightbar; 25% brightness and 50% of full brightness
(default)
.
Dim does not apply to Stop/Tail/Indicator, Alley Lights, Worklamps or Front Floods.
a)
Ensure the Lightbar is in ‘Standby’ mode
b)
Apply the green
(360/1)
wire to +ve permanently
c)
Apply the
blue
(Dim)
wire to +ve permanently
d)
Dim is now enabled at 50% of full brightness on all inputs
To decrease to 25% of full brightness: -
a)
Apply the green
(360/1)
wire to +ve permanently
b)
Apply the
blue
(Dim)
wire to +ve permanently
c)
Apply the grey
(Config)
wire to +ve permanently