M003 Issue: 1.5 Created by: Technical Dept.
12
February 2020
12.12
Flexi-Flash (FF)
-
Flash selected modules, in a variety of positions
Flexi-Flash allows the user to set a single LED module (or multiple modules) programmed to
this input function, in any desired format, giving the user total flexibility. This function can be
used to set up individual lightheads to flash or steady burn as required on the rear or front of
the lightbar, on either side or both sides. It also has independent flash pattern and colour
select on each setting.
In this version of software (v2.1) we have made it so there are 2 x more flexi-flash
functions, so on 3 separate wires, you can set up 3 different features rather than the
original 1 wire option. This is helpful to be able to set up a variety of new features in the
lightbar.
a)
Follow Section 10.1, selecting feature code 10-12 (
FF1, FF2, FF3)
12.13
Changing Flexi-Flash Operation
–
this selects the ‘position’ of the lamp
within the Lightbar such as
rear, front, front & rear and/or side (See Fig 1).
a)
Ensure the Lightbar is in ‘Standby’ mode
b)
Apply the programmed Flexi-Flash input wire to +ve permanently
c)
Apply the yellow
(sync)
wire to
-ve permanently
d)
Apply the grey
(Config)
wire to +ve permanently
e)
Apply the
blue
(Dim)
wire to +ve permanently
f)
Apply the
brown
(Pattern Select)
wire to +ve momentarily until the required operation is
set
g)
Release the grey ,
blue
and yellow wires
Flexi-Flash Sequence
1
Rear Only
6
Front Right only
2
Front Only
7
Front Left only
3
Front & Rear
8
Front & Rear Right only
4
Rear Right only
9
Front & Rear Left only
5
Rear Left only
Sync -ve
Permanent On
h)
To ‘alternate’ the flash mode against 360/1, 360/2, another flexi
-flash or other
mode (if not restricted)
–
simple apply the
brown
(Pattern Select)
wire to +ve for
five (5) seconds
–
this will alternate the flash pattern against the main function. To
revert
–
repeat operation.
12.14 Setting Flexi-Flash LED Modules -
this selects how many lamps (and which ones) activate for the
function, as shown in Fig 2).
a)
Ensure the Lightbar is in ‘Standby’ mode
b)
Apply the programmed Flexi-Flash function wire to +ve permanently
c)
Apply the yellow
(sync)
wire to
-ve permanently
d)
Apply the grey
(Config)
wire to +ve permanently
e)
Apply the
brown
(Pattern Select)
wire to +ve momentarily until the required number
of LED modules is set
f)
Release the grey and yellow wires
