Redline Communications RedCONNEX AN-80i PMP, User Manual

Page: 77 / 94

Red CONNEX TM
AN-80i
User Manual
70-00072-01-04b Proprietary Redline Communications © 2007 October 31, 2007
Page 77 of 94
5.3.16 Snmptrap
Use the snmptrap command to configure the SNMP trap message reporting.
Table 30: CLI - snmptrap
PTP PMP Description
√ √ add : add a new snmp trap to the snmp trap table. The index value is assigned
automatically. Up to eight settings can be entered.
snmptrap add <ipaddr> <port> <community> <Enter>
change : Modify the specified snmp setting.
snmptrap change <idx> [-p <port>] [-i <ip_add>] [-c <community] <Ent>
del : Delete the specified snmp setting.
snmptrap del <idx> <Enter>
print : List all SNMP trap settings.
snmptrap print <Enter>
5.3.17 Test
Use the test command to load the current edited (but not permanently saved)
configuration settings.
Table 31: CLI - test
PTP PMP Parameter/Description
√ √ config - AN-80i configuration settings
test config <Enter>
The system will operate using these setting for five minutes. During this five minute
period, you may enter 'save' at any time to permanently save the running configuration. If
you do not 'save' the configuration within five minutes, the AN-80i reboots -- discarding
the unsaved settings and loading the last saved configuration.
5.3.18 Upgrade
Use the upgrade command to upload a new software binary file to the AN-80i.
Table 32: CLI - upgrade
PTP PMP Description
√ √ ipaddr : Enter the IP address of the TFTP server.
filename : Enter the name of the binary file to be uploaded to the AN-80i.
upgrade <ipaddr> <filename> <Enter>
You must specify the TFTP server address and the full name of the binary file
(including .bin extension). The AN-80i software binary file must be located in
the default directory of the TFTP server.