Red
CONNEX
TM
AN-80i
User
Manual
70-00072-01-04b
Proprietary Redline Communications © 2007
October 31, 2007
Page 28 of 94
Wireless Configuration
Use settings on the following screen to configure the AN-80i wireless interface.
Figure 10
:
Web - Wireless Configuration Screen
RF Freq. [MHz]
:
Enter the center frequency for the RF channel. This setting must be
identical for both AN-80i systems operating as a wireless link. The options key controls
channel availability. Refer to Table 46: Spec. - Regional Identification Codes on page 90
for available channels. Use the Autoscan feature to enable use of multiple channels.
When the Auto Scan field is not checked, the PTP Slave will only register with a PTP
Master operating at the frequency specified in the RF Freq. [MHz] field.
Important
: To minimize interference, the channel frequencies for AN-80i links
operating in close proximity should be separated by a minimum of the channel size in
use (to avoid overlapping bands).
