Ellipse
INSTALLATION GUIDELINES
70-00159-01-09
Proprietary Redline Communications © 2015
Page 18 of 52
April 29, 2015
2.4
Configuration and Management
The following methods are available to monitor and configure the Ellipse system.
ClearView NMS Application
The Ellipse can be configured and monitored using the SNMP-based Redline ClearView
NMS. The Redline Management Suite is a set of applications designed to assist
provisioning, monitoring and administration of the Redline components deployed in
Radio Access Networks (RANs). Contact your Redline representative or visit the Redline
website for further information about the Redline ClearView NMS application.
Telnet (CLI)
Use a standard Telnet client to access all settings and statistics necessary to configure
and monitor the operation of the Ellipse. Use the following steps to monitor and
configure the Ellipse.
Using CLI, open a Telnet session to the unit IP address.
When the command prompt screen appears, login to the Ellipse. The factory default
credentials are:
username: admin
password: admin
The Telnet session is logged out automatically when no commands are received (idle)
for a period of ten minutes. Use the following command to exit immediately from the CLI:
logout [ENTER]
The Ellipse supports two concurrent Telnet sessions. The first admin session opened
has full read/write capabilities. If a second session is opened, it has read-only access.
Web Browser (HTTP)
Use a standard Web browser to access all settings and statistics necessary to configure
and monitor the operation of the Ellipse. To monitor and configure the Ellipse using
HTTP, open a Web browser (Internet Explorer 6 or higher recommended) and enter the
unit IP address. For new systems, the default IP address is 192.168.25.2. The following
login dialog should be displayed:
The default username is 'admin' and the default password is 'admin'.
There is no logout
command on the Web interface.
