Ellipse
INSTALLATION GUIDELINES
70-00159-01-09
Proprietary Redline Communications © 2015
Page 46 of 52
April 29, 2015
The following table lists the pinout for the PoE and Ethernet ports.
Table 16: Reference: Pinout for POE and ETH Ports
Pin
Description
PoE
ETH
1, 2
Data Pair 2
Data Pair 2
3, 6
Data Pair 3
Data Pair 3
4, 5
+Ve (out)
N/C
7, 8
-Ve (out)
N/C
LED Indicators
Use the following table to determine the current mode of operation.
Table 17: Reference: DC-DC PoE LED Indicators
Mode
AF LED
AT LED
LED Status Indication
AF Mode
ON
OFF
AF Mode active (~13W) (e.g., AN-80i)
Slow Blink
OFF
AF Mode: Over-load or short-circuit.
At Mode
ON
ON
AT Mode active (~25W) (e.g., wireless sector
controller)
Slow Blink
Slow Blink AT Mode: Over-load or short-circuit.
Non
Functional
Fast Blink
OFF
Input voltage out-of-range or
PoE over-temperature
DC power Connections
The DC supply connections are located on the front panel. This is a keyed Buchanan
796864-5 (or equiv.) connector accepting 12 to 24 AWG wires. Dual isolated floating
power supply inputs are provided to accommodate deployments with backup power
(e.g., A + B battery banks). All power inputs include overvoltage and reverse polarity
protection.
Table 18: Reference: DC-DC PoE Power Connections
Feature
Description
+V1/-V1
Positive and negative input for primary power supply.
+V2/-V2
Positive and negative input for secondary power supply.
GND
Common system ground. This sector controller is connected directly to
the chassis and the ground lug on the back of the PoE.
PWR LED
LED is on when power is detected on either V1 or V2 pairs.
Cable Gauge
Power / Ground:
#12 to #24 AWG
Chassis Ground:
#10 Lug