22
16.0 MAINTENANCE
Time schedule
Check/Grease point
Method
Before every use
Check for loose bolts/nuts
Presence and readability of the
safety stickers
(Please refer to Figure
5)
Tighten loose bolts/nuts with
the correct tightening moment
Replace these if not present or
damaged
After the first 20 working
hours (new or repaired)
Grease the roller bearings of the
front and rear roller and of the
driveline
Check for loose bolts/nuts
Check the tension of the V-belts
Use EP2 grease
Tighten loose bolts/nuts with
the correct tightening moment
If necessary, adjust the tension
of the V-belts (see Ch. 16.1)
After every 100 working
hours or annually
Grease the roller bearings of the
front and rear roller and of the
driveline
Check the gearbox for oil
leakage
Check the oil level in the
gearbox
Check for loose bolts/nuts
Check the tension of the V-belts
/ wear & tear
Check the wear of the brushes
Check and grease the PTO axle
Use EP2 grease
Replace or repair
If necessary, top it up until the
edge of the filling opening
Tighten loose bolts/nuts with
the correct tightening moment
If necessary, adjust the tension
of the V-belts (see Ch. 16.1) or
– if necessary – replace the V-
belts
Rotating Brush:
If necessary, replace brush
Sliding brush:
If necessary, replace or repair
See the PTO manual
