16
7.0 ADJUSTING THE ANGLE OF THE JIGGING SIEVE
1
2
3
4
5
6
7
Figure 13
If the receptacle is catching too much material that should have been sieved, it is possible to
allow the jigging sieve more time for sieving the material.
This is done by placing the jigging sieve under an angle.
The procedure is as follows
(see Figure 13)
:
Make sure that the tractor/Verti-Top is blocked well and cannot move
on its own accord!
Switch off the tractor before descending!
1. Open the latches (1) on both sides of the Verti-Top.
2. Open the inspection hatch (2) and block the hatch in the blocking strip (3).
Make sure that the inspection hatch is blocked well and cannot fall
shut on its own accord!
3. Loosen the nuts (4) one turn on both sides of the machine.
4. Using the handles (6) on both sides, adjust the jigging sieve (5) so that it is parallel
and at the required angle. For this purpose, make use of the indication sticker (7).
5. Tighten the bolts/nuts (4) on both sides of the machine.
6. Take the inspection hatch (2) out of the blocking strip (3).
7. Close the inspection hatch (2) carefully.
BE CAREFUL not to get any parts of your body jammed!
8. Secure the inspection hatch (2) with the latches (1) on both sides of the machine.
