HoneyBadger Installation Manual
HoneyBadger Install Version 2
Page 14 of 32
Issue Date 18/07/2022
Using the supplied x12 MC4 branch connectors up to 4 strings can be paralled for each MPPT.
An example for paralleling thre strings of 2 panels each is shown below.
Note that the in-line fusing is not shown, but is required.
The maximum 50A rating of the MC4 connectors is not exceeded if 6mm2 PV cable is used after the
second branch connector. 4mm2 PV cable can be used before the second branch connector as the
current is below the 30A rating with 4mm2 cable.
Step 4. Electrical connections
To access the cable connection points, remove
the faceplate by undoing the 4 screws holding
it in place.
It is also possible to remove the vents on the
sides of the unit by unscrewing the four corner
screws.
This allows access into the unit to pull through
cables, as well as accessing the
communications area on the other side of the
unit.
NOTE: Before proceeding any further, ensure that all breakers and isolators, as well as those supplying
power to the unit, are turned OFF.
