COVER HS Series – User manual
COMEX S.A.
6
Remove lateral protection. Unpacked UPS looks like the figure below.
Figure 2-3 View of the power supply after removing the housing
Tip: Remove the screws connecting the UPS power casing to the wooden pallet, and then place
the UPS at the installation point. Disassembly should be carried out with care not to scratch the
case.
Verify that the supplied equipment is properly labeled on the back of the UPS door. The label
contains basic information about model, power, etc.
Note: Disposal materials should be disposed of in accordance with local environmental
requirements.
2.4.2
Setting up
To ensure that the power supply is properly mounted, consider the following:
1.
The UPS and battery compartment that will work with it should be large enough to
accommodate the various components of the system. The dimensions and weight of the
UPS are described in the further part of this manual. The dimensions and weight of the
racks / cabinets with batteries depend on the chosen system's autonomy and therefore
the quantity and capacity of the battery. This information should be obtained directly
from the distributor.
2.
Due to the large dimensions and weight of the equipment, it is recommended that the
room provided on the UPS and batteries be located at level "0". Such location allows the
pallet truck to be transported directly to the place of foundation. Any other location that
