Point to Point Protocol over ATM (RFC 2364) – Windows NT 4.0
NOTE:
To perform the installation, logon as
Administrato
r. TCP/IP protocol must be installed prior to
the driver installation. At the
Network
window select the
Protocols
tab and verify that the TCP/IP is
present.
1.
On the Desktop, double-click
My Compute
r, and then double-click
Control Pane
l.
2.
In the
Control Panel
window, double-click the
Network
icon then select the
Adapters
tab. Click
Ad
d.
3.
The
Select Network Adapter
window appears. Click
Have Dis
k.
4.
Insert the CD labeled
R ECSPEED-2021P ADSL MODEM
into your systems CD drive.
5.
The
Insert Disk
window appears. In the text entry bar type in your systems CD drive location letter
(
D
for example ), followed by a colon (
:
), then a back slash (
\
), followed by the RFC2364 driver
for Windows NT 4.0. For example, type in:
D:\PPPoA\NT4.0
Then click
O
K.
6.
The
Select OEM Option
window will find the
RECSPEED-2021P ADSL PCI NI
C, Click
O
K.
7.
When the
Service Option
window appears, click
Advance
d.
8.
The
Service Options
window appears indicating the
Connection Addres
s &.
select ADSL mode
Enter in the
VPI
and
VCI
values provided by your ISP. Make sure the
Framing
is set to
VC MU
X
In the
Select ADSL Mode
section , select the mode(s) recommended by your ADSL service
provider. Click on the mode(s) required and then click
ok
NOTE
: The service mode type will be one of the following
ANSI T1.413 Issue 2
ITU G. 992.2 Annex A (G.lite)
ITU G. 992.1 Annex A (G.dmt)
9.
The previous
Service Option
window will appear, click
Nex
t.
10.
The
Setup message
window appears. It prompts
Remote Access Services (RAS)
will now be
installed. Click
O
K.
NOTE:
You may be asked to insert your Windows NT CD. Insert the
Windows NT CD
into the CD
drive and click
O
K. The
Windows NT Setup
window will appear. Enter the path <CD Drive letter> and
:\i386
(e.g.
D:\i38
6). Click
Continu
e.
11.
The
Add RAS Device
window appears. Click
OK
12.
The
Remote Access Setup
window appears showing itex
wana ..
.. Click
Network.
13.
The
Network Configuration
window appears showing the
Dial out Protocols:
Select and
check
(
) the
TCP/IP
protocol. Click
OK.
14.
The
Network
window will appear. Click the
Adapte rs
tab to verify that the
RECSPEED-2021P
ADSL PC NIC
has been found. Click on the
Protocols
tab and verify that the
ADSL
Management and Monitor Interface
is present. Click on the
Services
tab to verify that the
Remote Access Service
is present. Then click
Clos
e.
NOTE:
To review the Network window properties at any time, right-click the
Network
Neighborhood
icon and select
Propertie
s.
Summary of Contents for RECSPEED-2021P
Page 38: ......