Record Power TS200C, Original Instruction Manual

Page: 13 / 36

4. Saw Unit Assembly
- cont.
4.8 Fitting the optional right table
extension
If you are fitting the optional table extension
please proceed as below.
1. Take the 4 hex head bolts and washers, wind
them into the location holes on right side of the
main table leaving a gap of approximately 10mm
between washer and table
Fig.4.21
.
2. Hook the table extension onto the bolts
that have just been attached to the main table
Fig.4.22A and Fig.4.22B. Tighten the mounting
bolts to secure the table, but leave enough slack so
the table can be adjusted.
3. Taking a suitable straight edge, check the level
of the extension table to the main table Fig.4.23 .
To adjust the table; first lift the table extension
so it sits slightly proud of the main table and
tighten the hex head bolts the table is hooked on
to Fig.4.22A .
4. To flatten the table, take a mallet and a flat
wooden block and tap down on the extension
table Fig.4.25A until level with the main table
Fig.4.25B . When tapping the block strike as close
to the seam between the tables as possible.
TIP
The success of the table levelling procedure
largely depends on the adjustment of the
mounting bolts. The smaller the movement
required, the tighter the bolts should be.
However, the whole procedure really does
depend on feel. If the table isn't moving
enough when tapped, slacken the bolts
slightly. If it is moving too much tighten
them.
TIP
Level one end at a time, when one end of
the table is level tighten that bolt to lock
this in position before setting the other
end.
If the table has moved too low raise back up above
the main table and restart the procedure.
5. When you are satisfied that the tables are level
perform one last check along the length of the
tables with the straight edge
Fig.4.23
and fully
tighten the mounting bolts.
Fig.4.21
Fig.4.22A
Fig.4.22B
Fig.4.23
Fig.4.25A
Fig.4.25B
Approx. 10mm
Table hooked on to the bolts
12 13