Record Power TS200C, Original Instruction Manual

Page: 12 / 36

4.8 Adjusting the sliding table
The Sliding table is pre-adjusted in the factory. If it is out of
parallel or not sliding smoothly, you can make adjustments
according to the instructions below.
1.Checking the Height
Put the straight gauge on the sliding table and cast table
to check if the sliding table is the same height as the main
table (Fig 4.13). If it is not, you can adjust the four guide
wheels to correct. Two of them can only adjust vertically.
The other two are eccentric wheels and can adjust both
vertically and horizontally
(Fig 4.15).
2. To adjust the height of the two inside wheels. Adjust the height
of the guide wheels to the correct position with a screwdriver and a
wrench(Fig. 4.16).
3. To adjust the height of the outside wheels, loosen the nut at the
end of wheel shaft with a screwdriver and a wrench through the
adjusting window. Then adjust the self-lock nut to achive the correct
height with a wrench.(Fig. 4.17)
4. Saw Unit Assembly
- cont.
Fig.4.14
For vertical adjustment
For vertical and horizontal adjustment
4. When the tables are at the correct height, check the sliding table to
see if it moves smoothly. If not, loosen the bottom lock nut through the
window
(Fig. 4.17) and using a screwdriver rotate the eccentric wheels
to correct. (Fig. 4.18)
Fig.4.15
Fig.4.16
Fig.4.17
Fig.4.18
Self lock nut