ADJ.
(Adjust)
B u t t o n ,
C e l l C o m p a r t m e n
D i s p l a y i n V i e w f i n d e r
H o u r s a n d
Minutes
Seconds
Install the Lithium Cell for Time and Date Display
Pull out the cell holder.
2. Insert the cell in the cell holder
with the
terminal up.
3. Replace the cell holder.
Note:
The lithium cell should last
about one year. When it expires, the
date display shows
Reset the
date and time after replacing the cell.
Lithium cell battery. Replace only with 3-Volt micro lithium
cell -Duracell No.
Use of other
cells
present a risk of fire or
explosion. Must be disposed of properly. Never handle punctured or leaking
cells. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed.
If swallowed, consult a physician
for
The lithium cell used in this device may explode resulting in a fire or
chemical burn if mistreated.
Do not recharge, disassemble, heat above 212°F
or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and
sides of the battery.
Set and Record the Time and Date
Record the Time and Date
Whenever time and date (or date) appear in the
viewfinder, it will be recorded
on
the tape.
Press
DATE/TIME
to display and remove the
time and date.
Press
To Display in Viewfinder
DATE/TIME
and Record on the Tape
Button
Set the Time and Date
Install the lithium cell
described above.
2. Attach a power supply to the camcorder. Press
.
and hold small button on
POWER
while you
it to
CAM.
Place
ON/POWER SAVE
lever in ON.
5. Then, press
ADJ.
The flashing cursor will move to
the next part of the display.
6. Repeat steps 4 and 5 until you have entered the
correct month, day, year, hour including
AM
or
3. Use a straightened paper clip or pen to press and
PM,
and minute.
hold the
ADJ.
(adjust) button for about one second.
7. After setting the minutes, press
ADJ.
to start the
The reset date (1. 1994) and time
(AM
seconds. The seconds counter will start with
will appear in the viewfinder.
To correct the date or time after the clock has been
4. The month will flash. Repeatedly press
DATE/
started, repeat steps 3-7.
TIME
until the correct month appears.
