RCA Gemstar guide +, User Manual

Page: 31 / 96

Chapter 2 29
Using the Remote Control
GO BACK Returns you to the previous channel or previous screen in the
menu system.
GUIDE Brings up the
Listings
screen for the GUIDE Plus+ system.
INDICATOR Indicates the programming mode when programming the remote
to operate components. Lights when a button is pressed and a valid command
is sent. Turns red and blinks rapidly when batteries are low.
INFO Brings up channel banner with channel and viewing information. Press
again to remove the banner. In the GUIDE Plus+ system, brings up more
program information.
INPUT Toggles through the TV’s available input sources (Front Input, INPUT
1, INPUT 2, INPUT 3, INPUT 4, INPUT 5, DTVLink (if available), last-active
Antenna).
MENU Turns the Main menu on or off.
MUTE Reduces the TV’s volume to its minimum level. Press again to restore
volume.
OK When a menu is on the screen, press OK to select the item that is
highlighted.
ON•OFF When in TV mode, turns the TV on or off. If in another mode (VCR,
DVD, SAT•CABLE, AUX) and programmed, it turns the component on and off.
PIP Makes the PIP window appear and disappear (See Chapter 3 for more
information about using PIP.) Locks/unlocks video window in GUIDE Plus+
system.
REVERSE, PLAY, FORWARD, REC•VCR+, STOP, PAUSE If programmed,
provides transport control for some remote-controllable VCRs, DVD players,
and CD players. Press REC•VCR+ outside of the GUIDE Plus+ System to set a
manual timer program or enter a PlusCode number.
SAT•CABLE Places the remote in SAT•CABLE mode. If Auto Tuning is
enabled, turns on the TV and tunes to the correct input channel.
SKIP Press once before changing channels and the TV returns to the original
channel after 30 seconds. Press repeatedly to add more time. Cannot be used
with the browser. Use CLEAR to cancel.
SWAP When using PIP, switches the main picture with the PIP window.
TV Places the remote in TV mode. Turns on the TV and tunes to the last-
viewed TV channel or input. Placing the remote in TV mode enables you to
access the TV’s menu system as well as tune to analog, digital, or cable TV
channels.
VCR1 Places the remote in VCR1 mode. If Auto Tuning is enabled, turns on
the TV and tunes to the correct input channel.
VCR2 Places the remote in VCR2 mode. If Auto Tuning is enabled, turns on
the TV and tunes to the correct input channel.
VOL – or VOL + Decreases or increases the TV’s volume when the TV Audio
Output option is set to Variable Speakers On .
Tip
To turn off most the RCA, GE, and Proscan
components that are connected to the TV, press
ON•OFF twice within two seconds.
This feature only works with most RCA, GE, and
Proscan products.