RCA Gemstar guide +, User Manual

Page: 14 / 96

Connections & Setup
12 Chapter 1
R
L
LEFT
EXT
SPEAKER
SELECT
RIGHT FIXED/VARIABLE
AUDIO
OUTPUT
EXTERNAL SPEAKERS
INT W/
EXT
SURR
VIDEO
I N P U T 1
AUDIO
I N P U T 1
L/
MONO
R
VIDEO
I N P U T 2
AUDIO
I N P U T 2
S-VIDEO S-VIDEO
VIDEO
I N P U T 3
AUDIO
I N P U T 3
V
L/
MONO
R
V
L/
MONO
R
V
P
B
Y
P R
L/
MONO
R
VIDEO
I N P U T 4
AUDIO
I N P U T 4
AUDIO
I N P U T 5
L/
MONO
R
V
P
B
Y
P R
V I D E O
I N P U T 5
R
L
LEFT
EXT
SPEAKER
SELECT
INTERNAL
SPEAKER
SOURCE
MAXIMUM AMPLIFIER POWER RATING
(60 WATTS into 8 OHMS)
CENTER CHANNEL INPUT
RIGHT FIXED/VARIABLE
AUDIO
OUTPUT
EXTERNAL SPEAKERS
TV EXT AMP
INT W/
EXT
SURR
ANTENNA B
INPUT
ANTENNA A
INPUT
ETHERNET
G-LINK
VIDEO
RECORD
OUTPUT
AUDIO
R
L
DIGITAL
AUDIO
OUTPUT
TV
Back of Left Speaker
–
+
Back of Right Speaker
–
+
DVI-HDTV
How to Connect: TV + Speakers Without A/V Receiver
You can connect two external speakers to the TV: one to the RIGHT terminal, and one to the LEFT terminal.
1. If necessary, remove the vinyl covering from the ends of the speaker wire and twist the wire core.
2. Open the lever on the speaker terminal.
3. Insert the wire core into the hole. Be sure to connect the (+) to (+) and (-) to (-).
4. Close the lever. Pull gently on the wire to see that it’s connected securely.
5. Set the SPEAKER SELECT switch to INT W/EXT SURR.
• If you connect speakers and place the EXT/INT W/EXT SURR switch on the TV back panel in the INT W/
EXT SURR position, you get audio from the internal speakers as well as L minus R from both external
speakers. This connection gives you a matrix surround effect.
• If you connect speakers and place the switch in the EXT position, you get audio from the external
speakers only. The TV’s internal speakers are turned off.
6. Go to the Audio menu and Fixed/Variable Out screen and make sure V ariable Out - Speakers On is selected.
Notes : The external speaker rating is 8 ohms with 30 watts total power
handling capabilities.
When connecting the speaker wire, make sure you connect the positive
(+) terminal on the TV to the positive (+) terminal on the speaker. One
side of the speaker wire is usually marked with a white stripe to help you
match the terminals correctly. If the (+) and (-) terminals are not matched
properly, the speakers will not be “in phase,” causing reduction in bass
frequencies.
Do not allow the wire core to touch other wires or terminals. Damage to
components could result if the cores of two wires touch.
Arrange the speakers in your TV room to achieve maximum sound
quality.
Caution: DO NOT connect your audio/video receiver’s outputs or its
center speaker output to the red and black EXTERNAL SPEAKERS OUTPUT
on the TV. Damage to TV may result.
Speaker wire