RC Logger 88002RC, Operating Instructions Manual

Page: 18 / 40

18
Should you use your computer remote control, this should be programmed without using a mixer in the
standard program.
To correctly align the pilot stick for the desired control commands, it is necessary to programme the
RC EYE 450 with the used transmitter. In the process, the quadrotor’s electronics system memorises which
channel which control command broadcasts. As a basic principle, you can freely choose the configuration
of the control handle (according to your habits), however, it is recommended that beginners follow the
recommended examples.
Ex factory, the RC EYE 450 is configured to “mode 2”. The examples are based on the factory settings
for the optional accessories set with the transmitting equipment and an established configuration from the
experience of many model pilots.
Decide which configuration you wish to program and carry out the programming of the channels
correspondingly.
Further possibilities for control mode 1, 3 or 4 (modes 1, 3 or 4) can be found in the instructions in this
chapter under the heading “Possible flight modes” on page 22.
For monitoring the configuration, indicating malfunction or operating status, a red and a green LED are
installed on the control board. The respective indications can be seen in the table in the following chapter
“12. LED Displays” on page 27 in this instruction manual.
When using multiplex remote controls, the servo protocols must be adapted for all four
functions (throttle, aileron, elevator and rudder) from “MPX” to “UNI”.
Programming of the channels from the transmitter (general)
> LD1 (the green LED)
> LD2 (the red LED)
> X5: Interface to extension boards
> X1 and X2: Interface to motor drivers