RC Logger 88002RC, Operating Instructions Manual

Page: 15 / 40

15
assembly of the stabilizer
1. Peel off the protective films from the surfaces of the stabilizer.
2. Peel off the protective film from the stabilizer pads (Box 3-h-IV) and stick them to the outer corners on
the underside of the stabilizer.
3. Cut the magic tape with adhesive tape at the back into four pieces and stick them to the outer corners
on the upperside of the stabilizer.
4. Insert the four pillars throught the pre-drilled holes and secure them from the underside with screws.
The pillars serve for the canopy attachment (“Mounting of canopy” on page 16).
5. Place the stabilizer on the top body frame, fasten it at each corner with a screw for the stabilizer
(ø2.8 x 15 mm, silver) and a wave washer.
6. Place the red and black Velcro® straps around the legs and stabilizer. Mind the magic tape pieces.
The red Velcro® straps indicate the “front” of the RC EYE 450.