Raytheon Pathfinder ECDIS, Operator'S Manual

Page: 93 / 370

Operator Manual
Raytheon Anschütz GmbH
Germany
R
ECDIS
4 − 21
3655DOC020102 Edition: 30.MAR.2007
4.4.2 Chart Alignment (dialog box detailed information)
The chart alignment process must be accomplished each time the paper chart is
placed on the digitizing table. The paper chart must be aligned each time that
the chart is placed on the digitizing table.
The chart alignment process is automatically invoked from the Chart Selection
dialog box A pop
− up dialog box as shown below will appear with several fields
that must be filled in and a set of instructions for each step of the alignment
process. The following sections describe the fields and where to obtain the
information to properly fill in the fields during the alignment process.
Figure: 4 − 10 Chart Alignment dialog box
Secure Paper Chart
The paper chart must be securely attached to the digitizing table prior to
beginning the alignment process. If the paper chart slides at any time during the
alignment process then the paper chart should be realigned.
First Alignment Point
Using the puck at the digitizing table, place the cross hairs over the upper most
and left most major latitude and longitude crossing point. Left click the puck. The
latitude and longitude fields for the first point will be available for editing. Enter
the latitude and longitude of the crossing point that was selected with the puck.
Select Accept if the parameters are acceptable.