Raytheon Pathfinder ECDIS, Operator'S Manual

Page: 249 / 370

Operator Manual
Raytheon Anschütz GmbH
Germany
R
ECDIS
8 − 21
3655DOC020102 Edition: 30.MAR.2007
Step 4 Select Change next to the datum list box and scroll through the pull −
down to select the datum of the chart from which you read off the
waypoint (see Figure: 1
− 13)
Step 5 To enter the latitude and longitude of a waypoint, type in the
hemisphere, degrees and minutes. If you express minutes to a tenth,
hundredth or thousandth of a minute, be sure to include a decimal
point (.).
Step 6 Label the waypoint by typing a label of up to 10 characters in the
Label text box.
Step 7 Enter a turn radius for the waypoint by clicking in the Radius text box
and entering the desired value.
Step 8 Click on Convert to convert the waypoint‘s datum into WGS1984 da −
tum. The converted coordinates appear in the Edit Route dialog box
Waypoint coordinates from the paper chart with different datum
( (not WGS 84) (see chapter 8.2.1.5)).
In this case read off the datum from paper chart. Click on Change and
select the corresponding datum from the opening datum list.
Enter waypoint coordinates in the Latitude/Longitude fields, and click
on
Convert . The coordinates will be converted and filled automatically
in the Lat/Lon of the waypoint group.
Step 9 Click on Accept . The waypoint appears in the waypoint list, and
a waypoint symbol appears in the display.
To enter additional waypoints, repeat steps 2
− 9. A waypoint
symbol appears at each location you specify and the route is
extended with fairlanes and a planned track (dashed).
Step 10 To enter a cross − track error, click in the XTD text box and enter the
cross − track limit in m. Click on Set to make the change.
The fairlanes on the display will be adjusted according to the
cross
− track limit settings.
Step 11 Click on Quit . The Save Route dialog box appears.
Step 12 To save the route, type a name of up to 25 characters in the text
box, then click on
OK . If you do not want to save the route, click on
Cancel .