53
g
WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the washer before servicing.
Never start the washer with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
37989
39. TIMER DOES NOT ADVANCE (Mechanical Timer Models only)
POSSIBLE CAUSE
TO CORRECT
Timer is designed to pause during fill periods.
Allow completion of fill period.
Inoperative timer.
Test timer, and replace if inoperative.
Loading door is open.
Close loading door. Loading door MUST be
closed any time washer is set to fill, agitate or spin.
Washer will not fill.
Timer pauses until pressure switch is satisfied.
Timer motor lead wire off timer terminal.
Refer to appropriate wiring diagram and reattach
wire.
Broken, loose or incorrect wiring.
Refer to appropriate wiring diagram.
Timer is designed to pause when going from agitate
Allow time for timer to go through that step. See
to spin.
diagram for information on time required.
Timer is designed to stop if an out-of-balance load
Open lid and automatically reset out-of-balance
has been encountered while washing clothes load.
switch when lid is closed.
Timer is designed to stop if washer drive motor has
Motor thermal protector reset time may vary
been over loaded and motor thermal overload has
depending upon the reason for the washer overload,
tripped.
however, it should reset within 15 minutes. Check
to ensure that washer was not overloaded with
clothes.
Is circuit breaker to washer tripped, disconnecting
Reset circuit breaker.
power to washer.
Washer will not fill.
Timer is designed to pause when going from spin into
rinse to allow the washtub to stop spinning before
filling, make sure that timer has advanced into fill
portion of rinse cycle.